DRIVE SYSTEM AND ENGINE INSTALLATION
5. Position trim cylinder rear connecting ends.
Alpha Trim Cylinder Installation
1. Install trim cylinders forward mounting hardware.
2. Coat area in trim cylinder between bushings with lubricant.
3. Replace anchor pin and install bushings and washers.
4. Attach E‑rings and plastic caps to end of anchor pin.
Tube Ref No.
5. Install trim cylinders rear mounting hardware.
6. Coat area in trim cylinder between bushings with lubricant.
7. Replace anchor pin and install bushings and washers.
Page 52 / 54
a
a -
Port trim cylinder
b -
Starboard trim cylinder
a -
Front anchor pin
b -
Bushing (port and starboard) (4)
c -
Flat washer (port and starboard) (2)
Description
2-4-C Marine Lubricant with
95
Teflon
b
c
7848
c -
Connecting ends (offset as shown)
a
c
e
b
d
4827
d -
E‑ring (port and starboard) (2)
e -
Plastic caps (port and starboard) (2)
Where Used
Trim cylinder hardware
SECTION - 6
Part No.
92-802859A 1
90-899883183 DECEMBER 2007