Table of Contents
Advertisement
DRIVE SYSTEM AND ENGINE INSTALLATION
2. On the vertical crankshaft center line, measure up from the bottom of the transom to the
X‑dimension selected previously. This is the crankshaft horizontal center line at the
X‑dimension.
3. Draw a line perpendicular to the vertical center line at the crankshaft horizontal center line.
c
Single engine
Cutting Out The Transom
1. Cut out transom using the Template or the Transom Drilling Fixture Kit (purchased separately).
Transom cutout template
2. Follow instructions indicated on template or provided with drilling fixture.
3. Ensure that centerlines on either the template or transom drilling fixture align with lines
previously marked on transom.
4. Drill two 6 mm (1/4 in.) pilot holes at a 60 degree angle for hole saw guides.
Page 6 / 54
a
b
7692
a -
Vertical center line
b -
X‑dimension that corresponds to
transom angle
7893
a
c
Dual engine
c -
Crankshaft horizontal center line
Transom drilling fixture kit
SECTION - 6
b
7693
7694
90-899883183 DECEMBER 2007
Advertisement
Table of Contents
