Table of Contents
Advertisement
DRIVE SYSTEM AND ENGINE INSTALLATION
4. Install exhaust pipe assembly as shown, using 4 bolts and lockwashers. Torque bolts.
Description
Exhaust pipe bolts
5. Position rear engine mount attaching hardware on inner transom plate mounts as shown.
3.0 MPI Engine Preparation
1. Remove and read all tags attached to engine.
2. Remove all hardware that secures engine to shipping container.
3. Connect battery cables to engine. Observe the following:
a.
b.
c.
Page 22 / 54
a b
a
a -
Exhaust pipe
a -
Fiber Washer (2)
Ensure that the grounding stud and starter solenoid terminal are free of paint or any other
material that could cause a poor electrical connection.
Install the battery negative (‑) cable directly to the ground stud on the port or starboard
side of the flywheel housing.
Install battery positive (+) cable directly to the large starter solenoid stud.
7838
b -
Bolts and lockwashers (4)
Nm
34
a
b
7839
b -
Locknut (2)
90-899883183 DECEMBER 2007
SECTION - 6
lb. in.
lb. ft.
25
Advertisement
Table of Contents
