Table of Contents
Advertisement
REMOTE CONTROLS
2. Ensure that when the shift cable from the control box is led through the side gunnel of the hull,
it does not have any extremely sharp bends in it as this will cause stiff shifting.
IMPORTANT: Remote control cables MUST BE THE CORRECT LENGTH; sharp bends on
too‑short cables result in kinks and too‑long cables require unnecessary bends or loops. Both
conditions place extra stress on the cables.
IMPORTANT: Shift cable/throttle cable lubrication points use 2‑4‑C with Teflon.
3. Before installing the shift cable into the control box, extend the stainless rod eye end of the
cable and lubricate it. Move it back and forth to allow even distribution of the lubricant.
b
Tube Ref No.
NOTE: Allow for clearance of cables directly behind panel mount remote control. The 4000 GEN
II Series Panel Mount Remote Control mounting surface must not exceed 25 mm (1 in.) thickness.
Cable radius at any one point must not be less than 305 mm (12 in.).
Mounting surface maximum thickness
Minimum cable bend radius at any point
4. Do not strap or clamp the control cables to any other cables or rigid structure within 91.4 cm
(3 ft) of the control box.
Page 8 / 10
Improper cable bend
a -
Remote control end
b -
Engine end
Description
2-4-C Marine Lubricant with
95
Teflon
4000 GEN II Series Panel Mount Remote Control
Description
7872
c
7874
d
c -
Adjusting barrel
d -
Lubricating point
Where Used
Shift cable end
90-899883183 DECEMBER 2007
SECTION - 8
a
Part No.
92-802859A 1
Specification
25 mm (1 in.)
305 mm (12 in.)
Advertisement
Table of Contents
