Mercury MerCruiser 3.0 MPI Installation Manual page 129

SECTION - 9
5. Observe the oil level in the reservoir.
a
The oil level should be within the "MIN" and "MAX" lines on the reservoir.
6. Unscrew and remove the fill cap assembly from the reservoir.
NOTE: The fill cap and cap vent are an assembled as a unit and should not be separated. Do not
remove or discard the cap vent.
IMPORTANT: Use only the specified lubricant.
7. Add lubricant to bring the oil level to within the "MIN" and "MAX" lines on the reservoir.
8. Install the fill cap assembly.
9. Check all trim line connection points for leaks. If fluid is visible at fittings, inspect the trim line
connection fittings.
90-899883183 DECEMBER 2007
a - Reservoir
a
a - Fill cap assembly
b
a
a - Fill cap assembly
PREDELIVERY PREPARATION AND STORAGE
b
b - "MIN" and "MAX" lines
b
7877
b - Cap plug
Typical
b - "MIN" and "MAX" lines
7876
7878
Page 5 / 24