Table of Contents
Advertisement
DRIVE SYSTEM AND ENGINE INSTALLATION
Order a spacer kit to connect the remote control shift cable when shift assist assembly is not used.
NOTE: Do not discard shift assist assembly until after it is used below.
IMPORTANT: Shift cable must be connected at the remote control for the appropriate rotation (LH
or RH) drive unit, as explained following:
RIGHT‑HAND ROTATION ‑ Control cable will have to be installed in remote control so that cable
end will move in direction "A" when shift handle is placed in the FORWARD position.
LEFT‑HAND ROTATION ‑ Control cable will have to be installed in remote control so that cable
end will move in direction "B" when shift handle is placed in the FORWARD position.
INSTALLATION
1. Remove shift assist assembly.
Page 38 / 54
b
a
a -
Clevis pin
b -
Washer
A
B
c
c c d
32845
c -
Spacer
d -
Cotter pin
6614
90-899883183 DECEMBER 2007
SECTION - 6
Advertisement
Table of Contents
