Power Trim Electrical Connection; Power Trim Pump Connections - Mercury MerCruiser 3.0 MPI Installation Manual

Table of Contents

Advertisement

SECTION - 6

Power Trim Electrical Connection

ABYC (American Boat and Yacht Council) installation recommends installing a battery switch in
the positive conductor of any battery or battery bank with CCA rating greater than 800 amperes.
(See ABYC for additional information)
ABYC further recommends, if a boat is equipped with a battery switch, the power trim pump may
not be connected to the continuously energized circuit (battery). It must be connected to the
switched side of the battery switch. Wire length requirements and location of circuit protection are
also specified.
MerCruiser has developed three methods to facilitate compliance with ABYC recommendations.
These come in the form of one standard production and two accessory kits.
Installations with the batteries (or battery banks) rated at less than or equal to 800 Cold
Cranking Amps (CCA) and without battery switches: The trim pump may be installed using
the wires supplied with the power trim pump and should be connected directly to the battery.
Installations with batteries (or battery banks) rated at more than 800 CCAs (requiring a battery
switch) or any boat with a battery switch:
a.
Accessory Part Numbers
Part Number
8M2000587
8M2000588

Power Trim Pump Connections

1. Connect power trim pump BLACK (–) battery cable to negative (–) battery terminal and pump's
RED (+) battery cable to positive (+) battery terminal or to the switched side of the battery
switch.
a
90-899883183 DECEMBER 2007
The red current conductor (for the trim pump) must be connected to the switched side
of the battery switch and either:
provided with circuit protection within 7 inches of the power source or
Provided with circuit protection within 40 inches of the point of connection with the
power source and sheathed the entire length of wire from the point of connection to
the source and the circuit protection device. This will require the use of an Accessory
cable kit.
Description
Cable Assembly – Trim Pump
Cable Assembly – Trim Pump
b
a -
Positive battery lead
DRIVE SYSTEM AND ENGINE INSTALLATION
Color
Length
Red
72 inches
Red
40 inches
6842
b -
Negative battery lead
Type
Fused
Sheathed
Page 33 / 54

Advertisement

Table of Contents
loading

Table of Contents