Table of Contents
Advertisement
SECTION - 6
5. Repeat alignment procedure until the alignment tool slides freely with normal force all the way
into and out of engine coupler splines. Do not turn the alignment tool.
IMPORTANT: Finished boat stringer must position engine so that a minimum mount adjustment
exists after front mount is adjusted down to stringer. This allows for future adjustments.
6. For center‑mount models, complete the following:
a.
b.
c.
d.
e.
f.
IMPORTANT: Adjust both front engine mount adjustment nuts equally to align the engine.
7. For side‑mount models, complete the following:
a.
b.
90-899883183 DECEMBER 2007
a -
Alignment tool
b -
Gimbal bearing
Set the engine on the stringer.
Relieve the hoist tension.
Attach the hoist to the center alignment eye.
Fasten front mount to the stringer.
Recheck alignment.
Tighten locknut and jam nut securely.
c
e
b
Center‑mount model
a -
Front mount
b -
Attaching bolts and flat washers
c -
Adjusting nut
Adjust the front engine mounts until they rest on the boat stringers.
Relieve hoist tension entirely and fasten both front mounts to the boat stringer using
appropriate hardware.
DRIVE SYSTEM AND ENGINE INSTALLATION
c
b
a
7786
c -
Engine coupler
a
d
b
7963
d -
Locknut
e -
Jam nut
Page 29 / 54
Advertisement
Table of Contents
