Mercury MerCruiser 3.0 MPI Installation Manual page 64

DRIVE SYSTEM AND ENGINE INSTALLATION
4. On side mount models, loosen both side engine mount adjustment nuts.
NOTE: On side mount models, an installation jig (91‑806794A1) can be used to align and adjust
engine mounts. Refer to instructions with the fixture for proper use.
5. Lift the engine into position in the boat using an overhead hoist.
6. Align the elbow with the exhaust tube.
7. To ease installation, apply soap and water into the exhaust tube.
8. If equipped with quick drain oil, complete the following procedure:
a.
Page 26 / 54
c
7789
3.0 MPI side mount model
a - Engine mount (2)
b - Adjustment nut (2)
c - Jam nut (2)
a - Exhaust elbow
b - Exhaust tube
e
b
a
a - Bilge drain plug
b - Tether
c - Quick oil drain hose plug
Push the end of the oil drain hose out of the boat hull through the flange.
a
b
a
b
32841
d
f
c
d - Flange
e - Toward interior of boat
f - Clip
SECTION - 6
c
a
b
7791
7771
90-899883183 DECEMBER 2007