Table of Contents
Advertisement
SECTION - 6
3. Push the dribble valve stem in until gear lube appears, then release.
4. If the gear lube monitor is below the "OPERATING RANGE" line, fill the gear lube monitor with
specified fluid. Do not overfill.
Tube Ref No.
5. Install the gear lube monitor cap. Ensure that the rubber gasket is inside the monitor cap. Do
not overtighten the cap.
IMPORTANT: Position the rubber gasket properly in the bell housing bore before installing the
drive unit to prevent water leaking into the boat.
6. Ensure that the rubber gasket and water passage O‑ring are properly positioned in bell
housing.
7. Coat the bell housing studs with lubricant.
Tube Ref No.
90-899883183 DECEMBER 2007
a -
Dribble valve stem
Description
High Performance Gear
87
Lubricant
a
c
b
a -
Rubber gasket
b -
Water passage O‑ring
Description
2-4-C Marine Lubricant with
95
Teflon
DRIVE SYSTEM AND ENGINE INSTALLATION
a
7851
Where Used
Gear lube monitor
c
7852
c -
Studs (6)
Where Used
Bell housing studs
Part No.
92-858064K01
Part No.
92-802859A 1
Page 43 / 54
Advertisement
Table of Contents
