Heat Pump Control Unit Power Supply 230 V; External Unit Power Supply 230 V~/400 V - Viessmann Vitocal 200-S Installation And Service Instructions Manual

Power supply
(cont.)
The assignment of the power-OFF (for compressor
■
and/or instantaneous heating water heater) is made
via the type of connection and by setting parameters
in the heat pump control unit.
In Germany, the power supply can be cut for a maxi-
mum of 3 x 2 hours per day (24 h).
The heat pump control unit/PCB must be supplied
■
without power-OFF. Tariffs subject to possible shut-
down must not be used here.
■ When using power generated on site (use of power
generated by the PV system to meet own require-
ments):
During the power-OFF period, it is not possible to
operate the compressor utilising power generated on
site.

Heat pump control unit power supply 230 V~

1/N/PE
230 V/50 Hz
A
F1 T6,3 AH
L1 L1
? ?
N N
X40
Fig. 32

External unit power supply 230 V~/400 V~

■ Economy tariff and power-OFF can be used.
No parameters need to be set when using economy
■
tariff with power-OFF. The compressor is shut down
during the power-OFF period.
■ During power-OFF, the diagnostic functions for the
external unit are not supported.
External unit power supply 230 V~
Type AWB/AWB-AC
201.B04
C N L ?
A
N L1
?
B
Fig. 33
Protect the power cable to the heat pump control unit
■
with an MCB/fuse of max. 16 A.
■ For accessories and external components that will
not be connected to the heat pump control unit, pro-
vide the power supply via the same MCB/fuse, or at
least on the same phase, as the heat pump control
unit.
Connection to the same MCB/fuse provides addi-
tional safety when the power is switched off.
Observe the power consumption of the connected
consumers.
■ The PE wire of the power cable must be approx.
10 mm longer than the N and L wires.
Note
This supply must never be blocked.
Max. fuse rating 16 A
■
Standard tariff (no optional economy tariff with
■
power-OFF facility)
■
Recommended power cable: 3 x 1.5 mm
(5 x 1.5 mm
Note
Free terminals for internal use.
201.B05/B07
Ni Li N L
? COM ?
0 0
A
? N L1
B
Fig. 34
Installation sequence
2 with power-OFF)
201.B10/B13
C2 C1
N L ? N L
?
A
? N L1
B
Fig. 35
2
35