Internal Unit: Main Pcb (Function Components 230 V~) - Viessmann Vitocal 200-S Installation And Service Instructions Manual

Electrical connection

Internal unit: Main PCB (function components 230 V~)

Information regarding the connection values
The specified output is the recommended connected
■
load.
■ The total output of all components connected directly
to the heat pump control unit (e.g. pumps, valves,
message facilities, contactors) must not exceed
1000 W.
If the total output is < 1000 W, the individual rating of
a component (e.g. pump, valve, message facility,
contactor) can be greater than specified. However,
the breaking capacity of the relevant relay must not
be exceeded.
The specified current indicates the max. switching
■
current of the switching contact. Observe total cur-
rent of 5 A.
Plug sYA
Terminals Function
211.5 Type AWB-AC:
AC Cooling control
3-way diverter valves for heating
water buffer cylinder bypass in cool-
ing mode
Plug sYS
Terminals Function
212.2 Heating circuit pump for heating cir-
cuit without mixer A1/HC1
A1
212.3 DHW circulation pump
212.4 3-way diverter valve for heating water
buffer cylinder bypass or heat pump
in the case of dual alternative mode
(cont.)
Set the required parameters during commissioning:
See from page 50.
Explanation
Connection values
Max. output: 10 W
■
Voltage: 230 V~
■
Max. switching current: 4(2) A
■
Connect the 3-way diverter valves for the bypass circuit in
parallel.
Explanation
This pump is connected in addition to the secondary
■
pump if a heating water buffer cylinder is installed.
Connect the temperature limiter to restrict the maxi-
■
mum temperature for underfloor heating systems (if
installed) in series.
Connection values
Output: 100 W
■
Voltage: 230 V~
■
Max. switching current: 4(2) A
■
Connection values
Output: 50 W
■
Voltage: 230 V~
■
Max. switching current: 4(2) A
■
Connection values
Output: 130 W
■
Voltage: 230 V~
■
Max. switching current: 4(2) A
■
Installation sequence
25