Viessmann Vitocal 200-S Installation And Service Instructions Manual page 75

Internal unit electrical equipment
Pos. Part
0001 Programming unit
0002 Controller and sensor PCB with cover (CU401)
0003 PCB with connection adaptor (SA136-A10)
0004 PCB with connection adaptor, ON/OFF switch (SA137-A10)
0005 Main PCB with cover (MB761)
0006 Expansion PCB with cover (SA135)
0007 Coding card
0008 AVI PCB (IU122-A10)
0009 Base support, controller and sensor PCB
0010 Base support, main PCB
0011 Luster terminals with cable harness 230 V~
0012 Switching module for instantaneous heating water heater
0015 Programming unit
0016 Locking bolts, left/right
0017 Slider, left/right
0018 Fibre-optic cable
0019 Connecting cable 4-pole, length 85 mm
0020 Ribbon cable AWG 28, 24 x 0.09 mm
0021 Cable trunking (set)
0022 Body-bound rivet
0026 Fuse and mains power terminal
0028 Control unit support
0029 Back panel, programming unit
0030 Retaining spring
0031 Outside temperature sensor NTC 10 k
Parts not shown
Pos. Part
0013 Power cable AVI PCB
0014 Cable harness, low voltage
0023 Mating plug for main PCB
0024 Mating plug for controller and sensor PCB
0025 Mating plug for expansion PCB
0027 Fuses 6.3 A (slow) (5 pce)
0032 Service instructions Vitotronic 200, type WO1C
0033 Operating instructions Vitotronic 200, type WO1C
(cont.)
Ω
Parts lists, internal unit
75