Reading From Files - Panasonic FP2-PP2T Technical Manual

7.5.2 Reading from Files

Read the parameter settings or data settings from files.
1. Select [File]  [Open] in the menu bar, or click [Open] icon in the toolbar. The following dialog
is shown.
2. Select the drive where the file is saved in the [Location of File] box.
3. Select the file name in the box listing the folders and files under the [Location of File] box.
If the file you want to read is not indicated, double-click the folder name where the file is saved.
Double-click the sub-folder names until the sub-folder where the file is saved is open.
4. Click the file name.
The following contents are recorded in the positioning setting file (* npm) that can be used in this
software.
・Axis information
・Parameter settings
・Data settings
・Data comments
5. Click [Open].
Key Point:
Click the file name indicated at the bottom of the [File] menu to open the file that was previously active
Note:
Both files for the positioning unit (Interpolation type) and the positioning unit RTEX are read, however, it
is necessary to change the unit type to read the files for the positioning unit RTEX.
Reference: <7.9 Changing Axis Information>
7-10