Specifications Of The Lan Port; Specifications Of The Rtex Port - Panasonic GM1 Series Reference Manual

11.4.3 Specifications of the LAN Port

Item
Number of ports
Communication interface
Baud rate
Max. segment length
Max. distance between nodes
Communication cable
Communication protocol
No. of
simultaneous
connections
Communication method
TCP/IP protocol
Functions
LED display
(Note 1) The standards cite 100m as the maximum, but noise resistance measures such as attaching a ferrite
core may be necessary in some cases, depending on the usage environment. Also, it is recommended
to position a hub near the control board, and limit the length within 10m.

11.4.4 Specifications of the RTEX Port

Item
Baud rate
Physical layer
Cable
Topology
Insulation method
Connector
Maximum cable length
Communication cycle
Command update period
WUME-GM1H-02
Specifications
2
Ethernet 100BASE-TX / 10BASE-T
100 Mbps / 10 Mbps, automatic negotiation
100m
100BASE-TX 2 segments
10BASE-T 5 segments
Shielded twisted pair (TIA/EIA-568B CAT5e or higher)
TCP/IP UDP
LAN1 Maximum 16 units (System connection: 1 unit, user connection: 15 units)
Max. 32 units, general-purpose: 16 units
LAN2
A cycle restriction is applied depending on the total number of
connections.
Full-duplex / half-duplex communication
TCP/IP compliant (IPV4)
● Modifying or holding the network settings (IP, Subnet, Gateway)
● Possible to set the same or different networks between Ethernet ports.
● Routing between Ethernet ports is not performed.
Lit when connection is established with the device on the Ethernet
LINK
network.
Flashes when some communication is performed such as transmitting
ACT
commands and responses with the devices with established connections.
Specifications
100 Mbps
100BASE-TX full duplex (IEEE 802.3u)
Shielded twisted pair (TIA/EIA-568B CAT5e or higher)
Ring
Pulse transformer
8-pin RJ45
Between nodes: 100 m, total length: 200 m
500 µs to 2 ms
500 µs to 4 ms
11.4 Communication Specifications
(Note 1)
11-25