Sony GY-8240FC Operation Manual page 77

1-2. Loop ID
Press $ or 4 to set the Hardware assigned loop ID.
A value among from 0 to 256 can be set. The default is "0."
When you press [ENTER], the set value is registered,
and the loop ID parameter selection mode is restored.
To cancel the change, press [ESC].
Pressing [SELECT] terminates the menu operation and
restores the normal operation mode.
(If [ESC] or [SELECT] is pressed, the previous value is
restored.)
Loop ID parameter
selection mode
[ENTER]
[ENTER]
Loop ID setup
Loop ID [ 0]
[ESC]
$ 4
[ENTER]
Loop ID setup
Loop ID [ 1]
[ESC]
. .
. .
. .
4
$
[ENTER]
Loop ID setup
Loop ID [126]
[ESC]
4
$
Loop ID setup
Loop ID [ 0]
To normal operation mode
[SELECT]
To set the ID to 0
To set the ID to 1
To set the ID to 126
2. Option 3 port
Set the parameters for the OPTION 3 port.
Press $ or 4 to select a parameter to be set.
When you press [ENTER], the setting for the selected
parameter is enabled.
Pressing [ESC] restores the SETUP menu item
selection mode.
Pressing [SELECT] terminates the menu operation and
restores the normal operation mode.
SETUP menu
item selection mode
SETUP menu :2
Option 3 port
[ENTER]
[ESC]
Option 3 port
IP address
$ 4
[ESC]
Option 3 port
Subnet mask
4
$
[ESC]
Option 3 port
Gateway address
4
$
Option 3 port
IP address
To normal operation mode
[SELECT]
[ENTER]
2-1. IP address
[ENTER]
2-2. Subnet mask
[ENTER]
2-3. Gateway
address
31 (E)