Internal Commands Upon Error Generation - Sony GY-8240FC Operation Manual

Internal Commands Upon Error Generation

Meanings of "x" in error codes 1x10 to 1xYY
Code Command Function
(Hex)
1 Continuous READ To continuously read necessary
data without stopping the tape
2 Continuous WRITE To continuously write necessary
data without stopping the tape
5 PREROLL To transport the tape to a
position before the specified ID
6 New TAPE To check for data on the loaded
tape
7 REWIND To rewind the tape
8 EJECT To eject the cassette from this
unit
E FAST FWD To fast-forward the tape
F STOP To set the tape to STANDBY
ON or OFF mode
D Other commands
Meanings of "x" in error codes 2x01 to 2xYY
and 3x01 to 3xYY
Code Command
(Hex)
0 Unspecified It must be one of the following
functions, but cannot be
specified.
1 EJECT To eject the cassette
2 UNTHREAD To thread the tape into the
cassette
3 STOP To stop tape transport
4 STANDBY-ON To rotate the drum in tape stop
status
5 PLAY To play the tape
6 CLEANING To run the cleaning cassette for
the specified time
7 STANDBY-OFF To stop the drum rotation in tape
stop status
8 REC To record on the tape
9 FF To forward the tape at the
highest speed.
A REWIND To rewind the tape at the
highest speed
B PREROLL To locate the specified point
according to the ID on the tape
C IDC SEARCH To locate the specified point
according to the internal
counter.
D DIAG Diagnosis in progress
F Others Functions that are not classified
in any of the above functions
Function
27 (E)