Table of Contents
Advertisement
3. Locate the locking tab
far as it will go to release the Mini-GBIC from the switch port slot
4. Grasp the sides of the Mini-GBIC
If storing or shipping the Mini-GBIC, insert the protective dust cover
protect the fiber ports.
3.6
INSTALLING AN OPTIONAL XENPAK (10GBASE-LR) MODULE
This section describes how to install a XENPAK module.
Caution: Carefully follow the instructions in this manual to avoid damaging the XENPAK module
and switch.
The XENPAK module and switch are sensitive to static discharges. Use an antistatic wrist strap
and observe all static precautions during this procedure. Failure to do so could result in damage to
the 10GBASE-LR and switch. Always leave the 10GBASE-LR in the antistatic bag or an
equivalent antistatic container when not installed.
To prepare and install a XENPAK module, proceed as follows:
Preparation
Before installing the XENPAK module, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the XENPAK module from the antistatic packaging.
2. Remove the XENPAK module from the packaging.
Installation
To install a XENPAK module, refer to
1. Hold the XENPAK module
➂
edge connector
2. Carefully align the XENPAK module
3. Push the XENPAK module
faceplate is flush against the Ethernet expansion module.
4. Turn the two thumbscrews
ZPIM1-06. This completes the XENPAK module installation.
➅
under the front end of the Mini-GBIC
➀
and pull it straight out of the switch port slot
Figure 3-4
➀
with the top side
➃
facing the port slot
➀
into the switch port slot
➄
clockwise and tighten to secure the XENPAK module to the
Installing an Optional XENPAK (10GBASE-LR) Module
and proceed as follows:
➁
facing up (as shown in
.
➀
with the port slot
➃
until the back of the XENPAK module
➀
. Push in on the locking tab as
➃
.
➄
into the Mini-GBIC to
Figure
➃
.
Hardware Installation
➃
.
3-4) and its
3-7
Advertisement
Table of Contents
Troubleshooting
