Table of Contents
Advertisement
Installing an Optional Module into the Switch
Optional modules are available for media expansion. These modules can
be installed into either of the two modular slots on the rear panel of the
switch.
To install an optional module into the switch, do the following:
1.
Disconnect power to the switch.
2.
Remove the blank metal plate (or a previously installed module) from
the appropriate slot by removing the two screws with a flat-head
screwdriver.
3.
Before opening the package that contains the module, touch the bag
to the switch casing to discharge any potential static electricity. Also,
use the ESD wrist strap included with the package.
4.
Remove the module from the anti-static shielded bag.
5.
Holding the module level, guide it into the carrier rails on each side
and gently push it all the way into the slot, ensuring that it firmly
engages with the connector.
Figure 2-2. Installing an Optional Module into the Switch
6.
If you are sure the module is properly mated with the connector,
tighten the retainer screws by hand to secure the module in the slot.
7.
Connect power to the switch.
20 Installation
DO NOT install slide-in modules with the switch
powered on. Be sure you power off the switch before
installing any module.
VH-4802
Advertisement
Table of Contents
