Enterasys Matrix E1 1G694-13 Installation Manual page 34

Installing an Optional XENPAK (10GBASE-LR) Module
Figure 3-4 XENPAK Module Installation
➀
10GBASE-LR (XENPAK) module
➁
10GBASE-LR (XENPAK), top side
➂
Edge connector (insertion side)
Removing a XENPAK Module
Caution: The XENPAK module and switch are sensitive to static discharges. Use an antistatic
wrist strap and observe all static precautions during this procedure. Failure to do so can result in
damage to the XENPAK module and switch. Always leave the XENPAK module in the antistatic
bag or an equivalent antistatic container when not installed.
To remove a XENPAK module from the switch
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the XENPAK module
2. Remove the network cable connected to the XENPAK module
3. Turn the thumbscrews
ZPIM1-06.
4. Grasp the thumbscrews
➃
slot .
5. Before storing or shipping the XENPAK module
completes the removal procedure.
3-8 Hardware Installation
À
➀
.
➄
counterclockwise to release the XENPAK module
➄
and pull the XENPAK module
Â
Á
Ä
➃
Switch port slot
➄
Thumbscrews (2)
refer back to Figure 3-4
,
➀
➀
straight out of the switch port
➀
, insert it into a static free container. This
Ã
and proceed as follows:
.
➀
from the