Sc Fiber Optic Cable Connection - Enterasys Matrix E1 1G694-13 Installation Manual

2. Refer to Figure 3-10
SC port interface connector
the SC port connection. Refer to
the installation.
Figure 3-10 SC Fiber Optic Cable Connection
➀
SC cable connector
➁
Latch keys (bottom of SC connector)
➂
SC port Interface connector
3. At the other end of the fiber optic cable, attach the SC connector to the other device.
4. Verify that a link exists by checking that the port RX LED
green, or solid green). If the RX LED is off, there is no link. Perform the following steps until it
is on:
a. Check that the device at the other end of the link has power turned on and is compatible.
b. Verify proper crossover of fiber strands between the port on the switch and the fiber optic
device at the other end of the fiber optic link segment.
and insert one end of the SC cable connector
➂
. Ensure that the appropriate cable is used for the application of
Appendix A
à Â
Á
for the appropriate fiber optic cable to be used in
Ä
À
➃
Link LED (RX)
➄
Activity LED (TX)
➃
is on (flashing amber, blinking
Connecting to the Network
➀ ➁
, key side down
Hardware Installation
, into the
3-17