Installing an Optional Ethernet Expansion Module
3.4.2
Installing an Ethernet Expansion Module
Caution: Expansion modules are NOT hot-swappable. The switch must be powered down before
an expansion module (ZPIM1-01 or ZPIM1-06) is installed or removed. Hot-swapping the
expansion module while the switch is powered on could cause the device to stop forwarding
frames.
Refer to
Figure 3-2
1. After completing the removal of the coverplate
➁
guides
inside the option slot
expansion module
2. Tighten the two captive screws
1G694-13 front panel
This completes the Ethernet expansion module installation. If you are installing options, proceed
as follows:
•
To install a Mini-GBIC, proceed to
•
To install a XENPAK module (10GBASE-LR) in a ZPIM1-06 expansion module, proceed to
Section
3.6.
Otherwise, proceed to
install the 1G694-13 into a standard 19-inch rack.
Figure 3-2 Installing the Ethernet Expansion Module
➀
Ethernet expansion module
➁
Guides
➂
Option slot
3-4
Hardware Installation
and proceed as follows:
➂
in the 1G694-13 front panel
➀
into the slot until its rear connector
➅
on the Ethernet expansion module
➃
.
Section
Section 3.7
to install the 1G694-13 on a shelf or tabletop, or
align the Ethernet expansion module
,
➄
is fully engaged.
3.5.
Á
Â
Ä
➃
1G694-13 front panel
➄
Rear connectors
➅
Captive screws
➃
. Then slide the Ethernet
➀
to secure it to the
Section 3.8
Ã
À
Å
➀
with the
to
Å