Brasilia OPUS Technical Manual page 38

6.A.1. AUTOTEST ON MACHINE START UP:
Each times the machine starts up, the software performs the auto test of the internal components.
During auto test, the display shows: " DG/BRASILIA
followed to the message: " DG/BRASILIA
and then the final message: " DG/BRASILIA
6.A.2. CLOCK PROGRAMMING:
• Press MODE for ± 3 sec.: the display flashes the editable parameter: "Clock set up
yy"
• Use key "+" and "-" to modify items HOURS AND MINUTES.
• Press ENTER to confirm.
• The display flashes the editable parameter: " Clock set up
• Use key "+" and "-" to modify items DAY - MONTH - YEAR.
• Press ENTER to confirm.
6.A.3. MACHINE START AND STOP CONTROL:
CONTROL WITH CLOCK:
• After the previously menu press MODE for ± 3 sec.: the display flashes the editable parameter:
"Auto On/Off On hh:mm"
• Is possible to program the starting time: use key "+" and "-" to program HOURS AND MINUTES, press
ENTER to confirm.
• The display flashes the editable parameter: " Auto On/Off
• Is possible to program the power-down time: use key "+" and "-" to program HOURS AND MINUTES,
press ENTER to confirm.
• To exit from programming mode press MODE key.
The machine will automatically start and stop at the programmed times.
Note: to disable machine start and stop control, program the same time for ON and for OFF (ex.: ON
= 0:00 - OFF = 0:00)
MANUALLY CONTROL:
The machine can also be started and stopped out of the programmed times: press "+" and contemporar-
ily "-" for at least 3 sec.
6.A.4. "CLEANING ALARM" - REGENERATION OF THE WATER SOFTENER FILTERS:
To warn the operator about the necessity of a water softener filters regeneration you can program
the displaying of "CLEANING ALARM".
• Press MODE until display shows: " Cleaning Alarm
• Digit a value from 0 (zero) and 99999 litres inclusive using key "+" to increase and key "-" to
reduce.
1) If display shows " Cleaning Alarm
2) If display shows " Cleaning Alarm
the display shows "CLEANING ALARM": this alarm does not stop the machine functioning and warns the
operator that filters regeneration is needed.
To erase the alarm display: press MODE and ENTER contemporarily for at least 5 seconds.
6.A.5. PREINFUSION:
The message "PREINFUSION" can be displayed in order to enable/disable the relevant function.
• After the previously menu press MODE.
The display shows the default setting " Preinfusion
• Modify with ENTER (ON←→OFF).
6.A.6. GRINDING CHECK
The machine has a grinding control function that warns the operator when the coffee brewing time is
out of the correct preset time (for ex. because of atmospheric variable condition - grindstones
wear etc...).
This function is usually disabled when the machine is delivered; to enable it please follow the in-
structions below:
• After the previously menu press MODE.
The display shows the default setting: " Grinding Check
• Modify with ENTER (ON←→OFF).
REV. 2 04/2007
SYSTEM CHECK ON "
hh:mm
0 " function is disabled.
xxxx " after having delivered the programmed water quantity,
(Only for espresso coffee groups)
TEST IN PROGRESS "
dd-mm-yy "
hh:mm dd-mm-yy "
Off hh:mm "
xxxxx ".
OFF ".
:
OFF "
hh:mm dd-mm-
ENGLISH - 13