Table of Contents
Advertisement
10. Select Work with DST environment.
|
|
11. Select System Devices (skip this step if using SST).
|
12. Select Console.
|
13. Use one of the following console choices to select the new console type.
v If you select Operations Console (direct), option 2, continue with step 14.
|
v If you select Operations Console (LAN), option 3, do the following:
|
a. The Verify Operations Console Adapters window appears. This is the resource found by the
|
|
system to be used for your LAN connection. If you receive the message No valid LAN adapter
available you did not satisfy the hardware requirements for Operations Console. If so, use F3
|
to exit to the DST main menu, then, start this topic again at step 1 above.
|
|
b. Press F11 to configure the adapter.
|
c. Enter the appropriate network data.
d. Press F7 to store the data.
|
e. Press F14 to activate the adapter for use by Operations Console.
|
14. Press F3 until you return to the DST main menu.
|
The system is now configured for use by your intended console type.
|
|
If you do not plan to use the twinaxial device as an alternate console do not remove it or its adapter at
this time. You may need it to debug a problem.
|
|
The iSeries system value QAUTOCFG must be set to ON. Use one of the following to verify or set this
system value on the iSeries server:
|
v Use the WRKSYSVAL QAUTOCFG OS/400 command.
|
|
v During a manual IPL, in the IPL Options window, select Y for Set major system options. Then, for
Enable automatic configuration, select Y.
|
|
Continue with Configure the PC to use the new console type after changing from a twinaxial console to
an Operations Console.
|
Configure the PC to use the new console type after changing from a twinaxial console to an
|
|
Operations Console: To change from a twinaxial console to an Operations Console, you must configure
the PC to use the new console type. To configure the new console type, see Set up Operations Console.
|
|
It is recommended that you perform an initial program load (IPL) to ensure there are no errors. Then, at
a later time, remove or move any hardware you planned for.
|
|
It is recommended that you power down the iSeries when removing adapter cards or cables.
|
Note: If the new console fails to work in OS/400 you may need to use another workstation to manually
|
delete the controller and device description associated with the old console device.
Changing from an Operations Console to a twinaxial console
|
|
Before you begin, make sure that you have satisfied all the Operations Console hardware requirements
for the PC and iSeries server.
|
|
To change from an Operations Console to a twinaxial console, you must perform steps on the server and,
optionally, on the PC.
|
1. Change the console from an Operations Console to a twinaxial console in a non-partitioned or
|
|
primary partitioned server
|
Use these instructions to change the console from an Operations Console to a twinaxial console in a
non-partitioned or primary partitioned server.
|
74
iSeries: iSeries Access for Windows Operations Console
Advertisement
Table of Contents
