Table of Contents
Advertisement
Once you are satisfied that the new console is working correctly you can proceed with any plans to move
|
|
or remove any adapter or configurations.
To delete the current configuration if you will not be using the cabled connection as a backup console do
|
|
the following:
|
1. Select the configuration name (under iSeries Connection).
2. From the Connection menu, click Delete.
|
3. Click Yes to confirm the deletion.
|
Change from a twinaxial console to Operations Console
|
Before you begin, ensure that you have satisfied all the Operations Console hardware requirements for
|
the PC and iSeries server.
|
To change from twinaxial to Operations Console, you must perform steps on both the PC and the server.
|
1. Change the console from a twinaxial console to an Operations Console in a non-partitioned or
|
|
primary partitioned server
Use these instructions to change the console from a twinaxial console to an Operations Console in a
|
non-partitioned or primary partitioned server.
|
|
2. Change the console from a twinaxial console to an Operations Console in a logical partition
|
Use these instructions to change the console from a twinaxial console to an Operations Console when
the console to be changed is located in a logical partition.
|
3. Configure the PC to use the new console type after changing from a twinaxial console to an
|
|
Operations Console
Use these instructions to configure the PC to use the new console type when you are changing from a
|
twinaxial console to an Operations Console.
|
|
Change the console from a twinaxial console to an Operations Console in a non-partitioned or primary
partitioned server: To change from twinaxial to Operations Console, you must perform these steps on
|
|
the server using the existing console:
|
1. Access Dedicated Service Tools (DST) or System Service Tools (SST).
2. Select Work with DST environment.
|
3. Select System Devices (skip this step if using SST).
|
4. Select Console.
|
5. Select the new console type.
|
|
v If you selected an Operations Console (LAN), do the following:
|
a. The Verify Operations Console Adapters window appears. This is the resource found by the
system to be used for your LAN connection.
|
If you receive a message stating that the LAN adapter was not found, you need to satisfy the
|
|
hardware requirements for Operations Console.
b. Press F11 to configure the adapter.
|
c. Enter the appropriate network data.
|
d. Press F7 to store the data.
|
e. Press F14 to activate the adapter for use by Operations Console.
|
|
v If you selected an Operations Console (direct), continue with step 6.
|
6. Press F3 until you return to the DST main menu.
|
The system is now configured for use by your intended console type.
If you do not plan to use the twinaxial device as a backup console do not remove it or its adapter at this
|
|
time. You may need it to debug a problem.
72
iSeries: iSeries Access for Windows Operations Console
Advertisement
Table of Contents
