IBM eServer iSeries Manual page 41

Note: The Operations Console component is not available using the Typical or PC5250 User options.
a. Required Programs
b. 5250 Display and Printer Emulator (if IBM Personal Communications (V5.7 CSD 1 minimum) is
not installed)
You do not need a license to use 5250 Display Emulation just for Operations Console, even though
the window says that you do.
Important: If your Operations Console configuration is going to support only the remote control
panel, you do not need to install an emulator.
c. Operations Console.
7. Click Next and follow the prompts.
8. Apply the latest service pack (program temporary fix (PTF)) for iSeries Access for Windows.
Apply iSeries Access for Windows service packs: You should have the latest Service Pack program
temporary fix (PTF) for iSeries Access for Windows and the latest level of iSeries Access for Windows on
your PC. Service packs are available in a PC-executable form at the following Web sites:
v The iSeries Access for Windows Service Packs page:
http://www.ibm.com/eserver/iseries/access/casp.htm
v The IBM FTP site:
ftp://ftp.software.ibm.com
Navigate down to the directory path: as400/products/clientaccess/win32/v5r3m0/servicepack.
Install AS/400 Operations Console Connection Modem
If you are configuring a local console directly attached to the server or a local console directly attached to
the server with remote access allowed, you need to install the AS/400 Operations Console Connection
Modem.
Note: The AS/400 Operations Console connection modem is not a physical modem but a logical device
driver that comes with Operations Console and allows a local console to connect to an iSeries
server. When it is present, it shows as AS400 Operations Console Connection in the Remote Access
Setup window.
Install AS/400 Operations Console Connection Modem for Windows NT
Use these instructions to install the AS/400 Operations Console Connection Modem for Windows
NT.
Install AS/400 Operations Console Connection Modem for Windows 2000
Use these instructions to install the AS/400 Operations Console Connection Modem for Windows
2000.
Install AS/400 Operations Console Connection Modem for Windows XP
Use these instructions to install the AS/400 Operations Console Connection Modem for Windows
XP.
Install AS/400 Operations Console Connection Modem for Windows NT: You must install the
Operations Console connection modem that is shipped with Operations Console in order for a local
console to communicate with the server using the Operations Console cable. Only use these instructions
if you are configuring a local console directly attached to the server or a local console directly attached to
the server with remote access allowed.
To install:
1. Click Start —> Settings —> Control Panel, and then click Modems.
2. If the Install New Modem window appears, go to the next step. Otherwise, if you are currently in
the Modem Properties window, click Add.
35
Operations Console