Table of Contents
Advertisement
Important: It is assumed the server is powered down. Do not power on the iSeries server until you are
instructed to do so.
Note: You can also use the following instructions if you are removing one or more cables from your PC,
server, or both.
If you have set up any personal computers that will be connected to the system unit:
1. Power off all PCs.
2. Unplug all PC power cords from the electrical outlets.
If you have not set up the PC that will be used as your system console:
1. Place the PC not more than 6 meters (20 feet) from the system unit.
2. Follow the instructions that came with the PC to set it up.
3. Power off all PCs.
4. Unplug all PC power cords from the electrical outlets.
You need to install the Operations Console cable if you want to use the console function (5250 emulation
or command interface to iSeries server). If you want to use the console function and the remote control
panel function, you need to install the Operations Console cable and the remote control panel cable.
This graphic is an overview of your system unit, console (PC) and Operations Console cable. This
overview is intended to show you a general setup. The port location and part numbers could be different
depending on the system and configuration that you have.
Cabling information is available with instructions and graphics to install your cables for each server
model. Select your server from this list:
v Model 250
44
iSeries: iSeries Access for Windows Operations Console
Advertisement
Table of Contents
