Table of Contents
Advertisement
Figure 2. iSeries Navigator and Operations Console configuration on the same network
However, if the network adapter and configured OS/400 LIND and the service network adapter as
defined by the service host name (interface name) are on separate networks, then an additional PC
LAN adapter is required.
Figure 3. iSeries Navigator and Operations Console configuration on separate networks
Verify Operations Console requirements
Use this information to verify that you have met all the hardware, software and cabling requirements for
Operations Console.
v Meet Operations Console hardware requirements provides information on PC and iSeries requirements.
v Meet Operations Console software requirements provides the software requirements for working with
Operations Console.
v Meet Operations Console cable requirements provides information on the supported servers, cables and
card locations.
v Verify available communications port provides information on the available communication ports.
Meet Operations Console hardware requirements: This section describes the PC and iSeries hardware
requirements for an Operations Console configuration.
Table 1 shows the PC requirements per operating system.
Table 1. PC requirements - processor and memory
Operating System (1,2)
Windows NT 4.0
Windows 2000/XP Professional
Notes:
1. See the iSeries Access web site for any updated PC requirements.
2. If you are using iSeries Navigator, refer to the requirements for installing iSeries Navigator.
Operations Console PC
®
v Pentium
300 MHz recommended
v 64 MB memory minimum (128 MB recommended)
v Pentium 500 MHz (P6 or equivalent compatible
microprocessor)
v 256 MB memory minimum
17
Operations Console
Advertisement
Table of Contents
