Table of Contents
Advertisement
a. Click Add.
b. In the Add RAS Device window, select the modem.
c. Click OK. You should be at the Remote Access Setup window.
7. If the Remote Access Setup window has an AS400 Operations Console Connection entry present,
a. Select AS400 Operations Console Connection, then click Configure.
b. Click Dial out only. Click OK.
c. Click Network.
d. Select TCP/IP. Click OK.
8. If the Remote Access Setup window does not have a PC modem present, go to step 11. If the
Remote Access Setup window does have a PC modem present, continue with step 9.
9. Select the PC modem. Then, click Configure. Do one of the following:
v To configure only a remote console, select Dial out only.
v To configure a local console to receive calls from a remote console through dial-up support, select
Receive calls only.
v To configure as both, select Dial out and Receive calls.
Click OK.
10. Click Network on the right side of the window. Do one of the following:
v To configure only a remote console through dial-up support, follow these steps:
a. For Dial out Protocols, select the TCP/IP check box.
b. Click OK.
c. Go to step 11 on page 41.
v To configure a local console to receive calls from a remote console, select the following values:
a. For Allow remote clients running, select the TCP/IP check box and clear any others (unless
your own operation requires them).
b. For Encryption settings, click Allow any authentication including clear text.
c. Click Configure (located to the right of TCP/IP).
d. For Allow remote TCP/IP clients to access, click This computer only.
e. Click Use Static address pool.
f. In the Begin field, type the address 192.168.000.005
g. In the End field, type the address 192.168.000.024
h. Select the Allow remote clients to request a predetermined IP address check box.
i. Click OK.
j. Click OK again. Go to step 11 on page 41.
v To configure as both a local console that receives calls and a remote console, select the following
values:
__ a. For Dial out Protocols, select the TCP/IP check box and clear any others (unless your own
operation requires them).
__ b. For Allow remote clients running, select the TCP/IP check box and clear any others (unless
your own operation requires them).
__ c. For Encryption settings, click Allow any authentication including clear text.
__ d. Click Configure (located to the right of TCP/IP).
__ e. For Allow Remote TCP/IP client to access, click This computer only.
__ f. Click Use Static address pool.
__ g. In the Begin field, type the address 192.168.000.005
__ h. In the End field, type the address 192.168.000.024
__ i. Select the Allow remote clients to request a predetermined IP address check box.
40
iSeries: iSeries Access for Windows Operations Console
Advertisement
Table of Contents
