Table of Contents
Advertisement
Crestron TPS-4500V & TPS-4500LV
CALIBRATION MENU
SETUP MENU
Operations Guide - DOC. 6160
Calibration Menu
Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button's image. Select the Touch Screen Calibration button to
display the CALIBRATION MENU, shown to the left. The CALIBRATION MENU
offers the choice to initiate calibration with the Perform Calibration button or
return to the previous screen with the Return button. Choose an option by touching
the correct button.
If you proceed to calibrate the touchpanel, the screen displays the message "Touch
Upper Left" centered on the panel with a cross hair in the corner. Touch the cross
hair in the corner of the screen to initiate calibration. Another message, "Touch
Upper Right", appears with a cross hair in the correct corner. Touch the corner of the
screen. A final message, "Touch Lower Right", appears with a cross hair in the
correct corner. Touch the corner of the screen to conclude calibration and return to
the MAIN MENU.
NOTE: When touching the screen during calibration, be as accurate as possible.
Use the tip of a capped pen or the eraser end of a pencil. To cancel calibration and
return to the CALIBRATION MENU without saving calibration data, create a
calibration error by touching the screen in an area that is opposite from the instructed
area.
Setup Menu
To access the SETUP MENU, shown to the left, press the Setup button from the
MAIN MENU. The SETUP MENU offers a series of buttons, which opens
additional menus and displays, which are detailed in subsequent paragraphs. Many
touchpanel options (i.e., standby timeout and brightness) are available directly from
the SETUP MENU and are explained in the following paragraphs. Other setup
parameters (i.e., interface, RS-232, and video) use additional menus and are detailed
in subsequent paragraphs as well. After setup parameters have been set, select the
Return button to return to the MAIN MENU.
NOTE: The current CRESNET ID (a.k.a. Net ID) setting is displayed in the upper
left corner of the SETUP MENU.
NOTE: All touchpanel settings are automatically saved in non-volatile memory.
The touchpanel display can be turned off (standby mode) when not in active use.
STANDBY TIMEOUT, located in the middle of the SETUP MENU, can turn off
the touchpanel when it is inactive for a specified time frame (minutes, shown as 30
in the illustration). When the touchpanel is activated, the last screen to be displayed
reappears. Minutes can vary from 0 to 120, where 0 disables the timeout. DOWN
and UP buttons decrease and increase the timeout, respectively.
Screen brightness may need to be altered because of ambient light conditions or
personal preference. BRIGHTNESS, located in the lower left corner of the SETUP
MENU, can change the brightness level of the display. The current brightness setting
is shown as a percentage in the SETUP MENU (e.g., 99% brightness is shown in the
illustration). Percentage can vary from 0% (low brightness) to 100% (full
brightness). DOWN and UP buttons decrease and increase the brightness,
respectively.
12 Inch Tilt/Lectern Touchpanels with Video: TPS-4500V & TPS-4500LV • 11
12 Inch Tilt/Lectern Touchpanels
Advertisement
Table of Contents
