Removing The Existing Belt Cover, Bracket, And Discharge Chute; Installing The Ce Kit - Toro 78463 Operator's Manual

8
Removing the Existing
Belt Cover, Bracket, and
Discharge Chute
No Parts Required
Procedure
Note:
Clean the area around the belt cover before
removing it.
1. Lower the mower deck to the lowest height-of-cut
position.
2. Remove the right belt cover
Figure 15
3. Remove the right belt-cover bracket, 2 washers
(60-inch mower deck only), and 2 flange nuts
from the mower deck
Note:
Retain the hardware that you removed
during this procedure so that it is available for
changeover.
Figure 16
1. Right belt-cover bracket
2. Washers-only on 152 cm
(60 inch) mower deck
(Figure 15).
g038092
(Figure 16).
g038093
3. Flange nuts
4. Remove the locknut, bolt, spring, and spacer
holding the deflector to the pivot brackets
(Figure 17).
1. Bolt
2. Spacer
3. Locknut
4. Spring
5. Remove the grass deflector
Note:
Retain the hardware that you removed
during this procedure so that it is available for
changeover.
9

Installing the CE Kit

For CE Machines Only
Parts needed for this procedure:
1 CE Kit
Procedure
For CE machines, you need to install the CE Kit; refer
to the Declaration of Conformity for the CE Kit model
number.
14
Figure 17
5. Spring installed
6. Grass deflector
7. J-hook end of spring
(Figure 17).
g015594