Getting Started; Unpacking And Initial Setup - Teledyne 100E Instruction Manual

Model 100E Instruction Manual

3. GETTING STARTED

3.1. Unpacking and Initial Setup

To avoid personal injury, always use two persons to lift and carry
Inspect the received packages for external shipping damage. If damaged, please advise
the shipper first, then T-API.
Included with your analyzer is a printed record (Form number 04551) of the final
performance characterization performed on your instrument at the factory. This record is
an important quality assurance and calibration record for this instrument. It should be
placed in the quality records file for this instrument.
Carefully remove the top cover of the analyzer and check for internal shipping damage.
• Remove the set screw located in the top, center of the rear panel
• Remove the screws fastening the top cover to the unit (four per side).
• Lift the cover straight up.
Printed circuit assemblies (PCAs) are static sensitive. Electro-static discharges,
too small to be felt by the human nervous system, are large enough to destroy
Before touching PCAs, fasten a properly installed grounding strap to your wrist
or touch a bare metal part of the chassis to discharge any electrostatic
Never disconnect electronic circuit boards, wiring harnesses or
Inspect the interior of the instrument to make sure all circuit boards and other
components are in good shape and properly seated.
Check the connectors of the various internal wiring harnesses and pneumatic hoses to
make sure they are firmly and properly seated.
045150102 Rev XB1
sensitive circuits.
potentials.
electronic subassemblies while the unit is under power.
CAUTION
the Model 100E.
NOTE
CAUTION
Getting Started
25