Power Connector Cable - HP OMEN 17 Maintenance And Service Manual

apply thermal gel are noted by small square brackets in white on the board. (3) Reinstall the
thermal module onto the system board.
Reverse this procedure to install the heat sink.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 5-9 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. Remove the heat sink (see
Remove the power connector cable:
1. Remove the Phillips M2.0 × 5.0 screw (1) from the power connector bracket.
2. Remove the bracket (2).
3. Disconnect the cable from the system board (3).
4. Remove the cable from the clip on the side of the fan (4).
5. Remove the power connector cable from the computer (5).
Reverse this procedure to install the power connector cable.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Heat sink on page 38).
29).
Battery on page 30).
Spare part number
M57115-001
29).