2.
Press down on the module until the side retention clips snap into place (3).
Card reader
To remove the card reader, use this procedure and illustration.
Table 5-6
Card reader description and part number
Description
Card reader
Card reader cable
Before removing the card reader, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the card reader:
1.
Remove the two Phillips M2.0 × 4.0 screws (1) that secure the card reader to the computer.
2.
Disconnect the cable from the ZIF connector on the card reader board (2).
36
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
29).
29).
Battery on page
30).
Spare part number
M57123-001
M57108-001