Rj-45 Door - HP OMEN 17 Maintenance And Service Manual

5. Remove the touchpad from the computer (3).
Reverse this procedure to install the touchpad.

RJ-45 door

To remove the RJ-45 door, use this procedure and illustration.
Table 5-16 RJ-45 door description and part number
Description
RJ-45 door
Before removing the RJ-45 door, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the left solid-state drive (see
5. Remove the heat sink (see
6. Remove the power connector cable (see
7. Remove the fans (see
8. Remove the system board (see
Remove the RJ-45 door:
▲ From the inside of the computer, insert a flat tool under the RJ-45 door (1), and then lift the door up to
remove it (2).
Preparation for disassembly on page
Bottom cover on page
Battery on page 30).
Solid-state drive on page
Heat sink on page 38).
Power connector cable on page
Fans on page 41).
System board on page
29).
32).
40).
44).
Component replacement procedures
Spare part number
M57116-001
29).
49