Table of Contents
Advertisement
Reverse this procedure to install the RJ-45 door.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
NOTE:
The display assembly is available as a spare part only at the subcomponent level. For display
assembly spare part information, see the individual removal subsections.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the left solid-state drive (see
5.
Remove the heat sink (see
6.
Remove the power connector cable (see
7.
Remove the fans (see
8.
Remove the system board (see
Remove the display assembly:
1.
Remove the antenna cable from the computer by releasing the tape (1) and then removing the antennas
cable from the computer (2).
50
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page
30).
Solid-state drive on page
Heat sink on page
38).
Power connector cable on page
Fans on page
41).
System board on page
29).
32).
40).
44).
29).
Hide quick links:
Advertisement
Table of Contents
