HP OMEN 17 Maintenance And Service Manual page 56

Table 5-15 Touchpad description and part number
Description
Touchpad
Touchpad cable
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the left solid-state drive (see
5. Remove the heat sink (see
6. Remove the power connector cable (see
7. Remove the fans (see
8. Remove the system board (see
Remove the touchpad:
1. Remove the two rubber pads from the outer screws of the touchpad bracket (1).
NOTE:
2. Remove the four Phillips M2.0 × 3.0 screws (2) from the touchpad bracket, and then remove the bracket
from the computer (3).
3. Lift the protective tape off the top of the touchpad (1).
4. Remove the three broadhead Phillips M2.0 × 2.0 screws (2) from the touchpad.
48 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Battery on page
Heat sink on page
Fans on page
System board on page
When installing the touchpad bracket, be sure to replace the rubber pads over the screws.
Preparation for disassembly on page
29).
30).
Solid-state drive on page
38).
Power connector cable on page
41).
44).
Spare part number
M62229-001
M57110-001
29).
32).
40).