Usb Board - HP OMEN 17 Maintenance And Service Manual

4. If the WLAN antenna is not connected to the terminal on the WLAN module, you must install a protective
sleeve on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.

USB board

To remove the USB board, use this procedure and illustration.
Table 5-12 USB board description and part number
Description
USB board
USB board cable
Before removing the USB board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the heat sink (see
6. Remove the left fan (see
Remove the USB board:
1. Remove the Phillips M2.0 × 5.0 screw (1) that secures the board to the computer.
2. Lift the board straight up to remove it (2).
Preparation for disassembly on page
Bottom cover on page
Battery on page 30).
Solid-state drive on page
Heat sink on page 38).
Fans on page 41).
29).
32).
Component replacement procedures
Spare part number
M57122-001
M57107-001
29).
43