Esc 3 N - Citizen iDP-3221 Series User Manual

ESC 3 n
[Function] Setting line feed rate of minimum pitch
[Code] <1B> H <33> H <n>
[Range] 0 n 255
[Outline] Sets the line feed width per line to [n basic calculation pitch] inches.
[Caution] The line feed width can be set separately for the Standard and Page modes.
The basic calculation pitch is set by GS P. Once defined, the line feed width is not changed
if the basic calculation pitch is changed by GS P.
Fractions resulting from calculation are corrected with the minimum pitch of the mechanism,
and the remainder is omitted.
• In Standard mode, this command uses the vertical (paper feed direction) basic calculation
pitch (y).
• In Page mode, this command acts differently depending on the start point:
The maximum settable line feed width is 1016 mm (40 inches).
maximum is trimmed to the maximum.
[Default] 4.23 mm
[See Also] ESC 2, ESC c1, GS P
(1) If the start point specified by ESC T is top left or bottom right, the command uses the
vertical (paper feed direction) basic calculation pitch (y).
(2) If the start point specified by ESC T is top right or bottom left, the command uses the
horizontal (perpendicular to the paper feed direction) basic calculation pitch (x).
58
iDP3221 User's Manual
A setting greater than this
CITIZEN