Table of Contents
Advertisement
When an Error Message Appears
If you cannot send a fax or the memory is full, or you encounter operation problems, a message appears on the
display. Find out more information about messages in the following list.
***DOWNLOAD MODE*** FAILED TO UPDATE
Failed to update firmware due to the following reasons:
- There is no firmware to update.
- Connection with a computer is disconnected.
- A transmission (print, etc.) is processing from other computer or application to the machine during
updating firmware.
●
Check firmware that you updated is the newest version.
●
Check a connection between the machine and computer.
Connecting to a Wired LAN(P. 303)
Connecting to a Wireless LAN(P. 304)
●
If they are connected by USB cable, see Getting Started.
●
If there is a processing job, wait until it is finished.
Access point cannot be found.
When automatic setting with WPS was attempted, a wireless router could not be detected within a
specific period of time.
●
Connect again paying attention to the time limit.
Setting Up Connection Using WPS Push Button Mode(P. 306)
Setting Up Connection Using WPS PIN Code Mode(P. 308)
An SSID or network key of a wireless router was entered manually, but the entry was incorrect.
●
Check the SSID and network key, and enter the correct ones again.
Checking the SSID and Network Key(P. 318)
Setting Up Connection by Specifying Detailed Settings(P. 314)
A wireless router could not be detected due to setting problems of the network to be connected.
●
Check whether the machine is properly installed and ready to connect to the network.
Installation/Settings Problems(P. 504)
●
If the problem persists, check the security settings of the wireless router.
An error occurred.
Connection is interrupted during transmission with a computer, or any kind of error has occurred.
●
Check whether a driver or software is correctly installed on the computer.
MF Driver Installation Guide
Troubleshooting
491
1053-07A
Advertisement
Table of Contents
