Konica Minolta REGIUS 190 Operation Manual page 49

REGIUS MODEL 190
No.
STATUS
11
ERASE MODE "x" ERASE MODE "x"
ALIGN CST TO LEFT
NOTE
12
ERASE MODE "x" BAD LAMP
ALIGN CST TO LEFT
13
ERASE MODE "x"
IMPROPER INSERTION
14
ERASE MODE "x" BAD LAMP
IMPROPER INSERTION
15
ERASE MODE "x"
CLOSE EJECT SLOT SHUTTER
16
ERASE MODE "x"
CLOSE EJECT SLOT SHUTTER
17
ERASE MODE "x"
REMOVE USED CASSETTE
18 ERASE MODE "x" BAD LAMP
REMOVE USED CASSETTE
19 ERASE MODE "x"
BAR CODE ERROR
20 ERASE MODE "x" BAD LAMP
BAR CODE ERROR
NOTE:
The number "x" suffixed to "ERASE MODE" in the above list shows the erase mode number.
If "x" is "1" : ERASE MODE 1 QUICK (High-speed erase mode)
If "x" is "2" : ERASE MODE 2 SLOW (Low-speed erase mode)
If the message "BAD LAMP CALL SVC" is displayed on the LCD panel, one of the two erasing lamps is
broken. This status, under which the erase time becomes longer, will not effect normal operation of REGIUS
MODEL 190. When both lamps are broken, however, operation of REGIUS MODEL 190 will not be possible.
As a precaution, if the message "BAD LAMP CALL SVC" is displayed, contact your Technical Representative.
ERROR MESSAGE
47
REMEDY
Status: ERASE MODE "x"
Align the cassette to be inserted to the left side.
Status: ERASE MODE "x"
The cassette has been inserted abnormally.
Push the "eject" button to remove the cassette.
Status: ERASE MODE "x"
The ejection slot shutter is open. Resolve the cause
and close the shutter.
Status: ERASE MODE "x"
Remove the cassette from the cassette stacker.
Status: ERASE MODE "x"
Insert the cassette again to be erased.
REGIUS MODEL 190 OPERATION MANUAL Ver.1.03 2004.12
p.36 Erasing the
REGIUS Plate