Konica Minolta REGIUS 190 Operation Manual page 15

Cautions Relating to the Power Supply and
the Power Cable
● Never hold the power plug with wet hands.
Never plug in or remove the power plug from the power socket with wet
hands: there is a risk of electrocution.
● Do not connect the ground to gas pipes.
Under no circumstances should the ground be connected to a gas pipe:
Gas
this could cause a gas explosion.
● The following points should be strictly observed in order to avoid the
risk of electrocution or fire.
Ensure that the unit is not exposed to water or other liquids. Make sure
also that clips, pins or other foreign objects are not accidentally introduced
into the main unit: this could lead to electrocution or fire.
• Always use the power cable provided with the unit.
• Always use a recommended power outlet as the power supply.
• Be careful to ensure that no dirt or dust accumulates on the
power plug or power plug pins.
• In the event that the power plug or power cable becomes hot, or if
the plug is loose when connected to the power outlet, usage
should be discontinued immediately and your Technical
Representative contacted.
● Do not use any power outlet other than the type specified.
Always use a wall outlet meeting the specified voltage and power supply
requirements. Usage of power outlets other than the type specified could
result in fire or electrical leak. Additionally, do not use the unit in a location
where an extension cable will be necessary.
● Do not use multiple outlet extension plugs.
Excessive current loaded on the power outlet could result in overheating and
consequent risk of fire.
● Do not use cables other than the power cable supplied with the unit.
Supply of current in excess of the ratings to the power cable could produce
the risk of fire. Additionally, in order to avoid the risk of electrocution or fire
due to damage to the power cable, the following cautions should be strictly
observed:
• Do not tug on the power cable.
• Do not twist the power cable.
• Do not bundle power cables.
• Do not fix the power cable in place using, for example, a stapler.
• Do not allow the power cable to become trapped between two
objects.
• Do not place objects on the power cable.
• Do not carry out modifications, repairs or other processes on the
power cable.
• Do not use a damaged power cable.
A damaged power cable should be immediately replaced by a power cable of
identical standard. For details of replacement, contact your Technical
Representative.
● The power cable should not be used near any heat generating devices.
● When the unit is to be left unoperated for extended periods of time, the
power plug should be disconnected from the power outlet.
WARNING
CAUTION
NOTE : If the contents of this page are not legible, order a new manual.
REGIUS MODEL 190 OPERATION MANUAL Ver.1.03 2004.12
13
p.20 Name of Parts