Konica Minolta REGIUS 190 Operation Manual page 16

Cautions for Installation, Movement, Maintenance
and Connection of the Unit
NOTE : If the contents of this page are not legible, order a new manual.
REGIUS MODEL 190 OPERATION MANUAL Ver.1.03 2004.12
● The person in charge of the system installation has to ensure that all
connecting devices comply with IEC 60601-1 as part of a Medical
System.
● Cautions Relating to Installation of the Unit
When installing the REGIUS MODEL 190, be sure to fix the adjuster foot
firmly in place. Any vibration or shock that causes the main body of the
unit to move could cause damage to the unit itself or peripheral devices or
objects.
● Cautions Relating to Movement of the Unit
Should the necessity to move the unit arise, contact your Technical
Representative.
● Do not install the unit in any location other than the one specified.
The unit should not be set up or installed in any of the locations detailed
below, or in any location not specified in this manual.
• Locations where the unit will be exposed to excessive amounts of
dust.
• Locations where the unit will be exposed to direct sunlight.
• Locations, such as near a hot water outlet, where the unit will be
exposed to excessive levels of humidity.
• Locations that are not level.
• Locations with poor air circulation, or where sufficient ventilation
cannot be ensured.
• Locations where the unit will be exposed to soot or steam.
• Locations where the unit will be exposed to extreme contrasts
between light and darkness.
• Locations where the unit will be exposed to heat, such as near a
heater.
• Locations within the vicinity of the patient which encloses a
space within the room 1.83m beyond the perimeter of the bed.
● Do not use an Ethernet cable other than the one specified.
The ethernet cable supplied with the unit or, alternatively, an ethernet
cable specified by Konica Minolta Medical & Graphic, inc., should be
used; all devices and connectors used with the cable should be carefully
checked before proceeding with connection. Regarding handling and
connection of the ethernet cable, the following cautions should be strictly
observed.
• Do not use damaged cable connectors.
• Do not place objects on the cable.
• Do not use a damaged cable.
• Do not tread on the cable.
• Do not use the cable if the connection is loose.
● Do not move the unit with power cables or other cables still connected.
Cables will be pulled tight resulting in dropping or tilting of the unit and
consequent injury.
Be certain to comply with any and all laws and government regulations
including electric codes and utility regulations, regarding the installation
and operation of this equipment.
CAUTION
14