Konica Minolta REGIUS 190 Operation Manual page 20

p.26 Handling the Cassette
NOTE : If the contents of this page are not legible, order a new manual.
REGIUS MODEL 190 OPERATION MANUAL Ver.1.03 2004.12
Cautions relating to Usage of the Cassette
● To prevent possible injury, be careful not to drop the cassette during
usage. Dropping the cassette on the foot may cause injury.
● Be careful not to pinch your fingers when opening/closing the
cassette lid.
● Because the magnet is used for the back plate of the read-only
cassette, do not bring the read-only cassette close to the person
wearing a pacemaker or to the other electronic devices.
● Cassettes should not be used in a location where they will not be
exposed to high temperatures, high levels of humidity, direct
sunlight or radiation.
● Cassettes should be used under the conditions: 10~30:, 80%RH or
less.
● Use only those exposure-only cassettes, read-only cassettes and
REGIUS Plates that are specified by KonicaMinolta and do not use
them for other purpose than specified.
● To prevent possible injury, make sure that the exposure-only
cassette lid is locked when it is carried to the other place.
● Loading of the exposed REGIUS Plate in the read-only cassette
should always be carried out in a darkroom. Use a blue safelight
when it is necessary. Loading the exposed REGIUS Plate under
daylight leads to deterioration of image recorded on the REGIUS
Plate.
● Make sure that the lock is engaged when inserting the read-only
cassette into the REGIUS MODEL 190.
● Be careful to ensure that the iron foil on the back panel does not
become soiled. Also, do not affix any labels to the back panel: if it is
necessary to affix a label, the label should not be affixed to the iron
foil portion. Be sure to peel it off before inserting the cassette into
the reader.
● Peeling or curling of the sheet laminated on the cassette's back plate
may lead to injury at the edge of the sheet depending on handling. If
peeling or curling of the sheet is observed, immediately stop using
the cassette and contact your technical representative for repair.
● Be careful that no foreign objects such as liquid (water, etc.), pins or
clips fall into cassette.
● Dropping, bending or applying a shock to the cassette or REGIUS
Plate may lead to deformation or breakage. Always handle them with
care.
● Do not leave the REGIUS Plate under the fluorescent lamp or
sunlight for an extended period of time.
● Be careful not to damage or soil the fluorescent surface of the
REGIUS Plate or inner parts of the exposure-only cassette.
● Never attempt to disassemble, repair or modify the cassette. This
may cause deterioration of the image quality as well as problems in
examination using the exposure-only cassette. Contact your
technical representative when a repair should be required.
● Anhydrous ethanol is a chemical agent. Be sure to comply with
safety regulations of the chemical manufacturer.
● Lead is used inner surface of the exposure-only cassette. Due care
should be taken when it is handled.
CAUTION
18