Protocol Settings; Printer Protocol Settings - Canon imageCLASS 2300 Network Manual

Protocol Settings

You can specify the protocol settings of the machine by using any of the following
software. Specify the settings using the easiest method.
•
NetSpot Device Installer (Canon software included on the Network User Software
CD-ROM)
•
NetSpot Console (via a web browser) (Canon software included on the Network
User Software CD-ROM)
3
•
A web browser (Remote UI)
• An FTP client

Printer Protocol Settings

You can install NetSpot Console or NetSpot Device Installer from the Network User
Software CD-ROM provided with the machine, and use it to specify the protocol
settings on the computer you are using.
For instructions on how to install NetSpot Console or NetSpot Device Installer and
how to specify the protocol settings using NetSpot Console or NetSpot Device
Installer, see "NetSpot Console," on p. 5-3, or "NetSpot Device Installer," on p. 5-2,
respectively.
IMPORTANT
•
The machine's MAC address is necessary. To check the MAC address using the control
panel, follow the procedure below to perform a test print.
1. Press
2. Press
3. Press
4. Press
•
Check that the machine is connected to the network and that the machine's power is
turned ON.
NOTE
•
You can also find online instructions on how to install NetSpot Console in the NetSpot
Console User's Guide or the Readme file, and how to set protocol settings in the NetSpot
Console User's Guide, Online Manual, or Online Help, all of which are included in the
NetSpot Console folder on the Network User Software CD-ROM provided with the
machine.
3-8

Protocol Settings

(PRINT) ➞
PRINT
off.
F1
(MENU) until <TEST MENU> appears.
F2 (ITEM) until <PRINT EN CONFIG> appears in the second line of the
display.
F4
(ENTER).
(OK) on the control panel; the Online indicator goes