4
2
5
The printer destination settings are complete.
2-28
Setting Up a Computer for Printing
If you are using LPD, change the port configuration
information.
❑
Click [Configure Port].
❑
Select [LPR] under [Protocol], enter "LP" in [Queue Name] under [LPR
Settings] ➞ click [OK].
NOTE
•
If you are using Raw, this step is not required.
•
You can specify a print queue in [Queue Name]. The following three print queues
are available (be sure to use only capital letters to enter a print queue):
- LP: The machine prints according to its spool settings. Normally enter "LP" as a
print queue
- SPOOL: The machine prints only after spooling a print job on the hard disk
regardless of its spool settings.
- DIRECT: The machine prints without spooling a print job on the hard disk
regardless of its spool settings.
Click [OK] to enable the settings.