Canon imageCLASS 2300 Network Manual page 80

•
If you are using LPD with Windows 95/98/Me, confirm that the spooling
settings are made correctly. (See steps 3 to 5 in "Windows 95/98/Me," on p. 2-
22.)
Cause 4 The name of the file being printed is too long.
Remedy Normally LPR (or the Microsoft TCP/IP Printer, if you are using Windows NT/
2000/XP) sends jobs either under the name of the application software used for
printing, or the file name. However, a job name longer than 255 characters
cannot be sent to the printer. To correct this problem, rename the file with a
shorter name.
Cause 5 The IP address of the computer from which data are to be sent to the machine is
not permitted in the IP Address Range Settings menu in the Remote UI.
Remedy Check the IP address range settings in the Remote UI. (See Chapter 2,
"Remote UI Functions," in the Remote UI Guide.)
Unable to Print from a NetWare Network
Cause 1 The machine and cable are not properly connected.
Remedy After checking the following connections, restart the machine.
Check that the machine is connected to the network using the proper cable.
(See Chapter 1, "Before You Start Using This Machine," in the PCL Printer
Guide.)
Cause 2 The NetWare network is not properly set up.
Remedy Check the following:
•
Confirm that the NetWare file server is running.
•
Confirm that there is sufficient disk space on the NetWare file server. Large
files cannot be printed if there is insufficient disk space.
•
Start NetSpot Console, NetSpot Device Installer, NWADMIN, or PCONSOLE,
and then confirm that the print queue is set up properly and is active.
•
Confirm that the network settings of the machine are correctly set. (See
"Printer Protocol Settings," on p. 3-8.) Check the following in particular:
- A valid frame type is selected from Frame Type.
- Print Server Name and Printer Number are correctly specified.
Cause 3 The computer that is printing is not properly set up.
Troubleshooting 6-3
6