Netware Network Setup Procedures - Canon imageCLASS 2300 Network Manual

NetWare Network Setup Procedures

To use a NetWare network, it is necessary to perform the following procedures.
1
3
2
3
4
IMPORTANT
•
It is recommended that the network manager perform steps 1, 2, and 3 above.
•
To configure settings with software other than NetSpot Console or NetSpot Device
Installer, TCP/IP protocol must be supported by your network environment.
•
When printing in a NetWare network, disable the banner page.
3-2

NetWare Network Setup Procedures

Network Cable Connection (See Chapter 1, "Before You Start Using This
Machine," in the PCL Printer Guide.)
Connect the network cables in accordance with the PCL Printer Guide.
NetWare Print Service Settings (See "NetWare Print Service Settings," on p. 3-
3.)
Specify the NetWare print service settings. To specify the settings, use:
•
NetSpot Device Installer (Canon software included on the Network User Software CD-ROM)
•
NetSpot Console (via a web browser) (Canon software included on the Network User Software CD-ROM)
•
NWADMIN or PCONSOLE (Novell software provided with NetWare)
Protocol Settings (See "Protocol Settings," on p. 3-8.)
Specify the protocol settings. To specify the settings, use:
•
NetSpot Device Installer (Canon software included on the Network User Software CD-ROM)
•
NetSpot Console (via a web browser) (Canon software included on the Network User Software CD-ROM)
•
A web browser (Remote UI)
•
An FTP client
Computer Settings for Printing (See "Setting Up a Computer for Printing," on
p. 3-10.)
Specify the settings for each computer you use for printing.