Netware Network Setup Procedures - Canon IMAGERUNNER 4570 Network Manual

NetWare Network Setup Procedures

To use a NetWare network, it is necessary to perform the following procedures.
1
4
2
3
4
IMPORTANT
•
It is recommended that steps 1, 2, and 4 above be performed by the network manager.
•
To configure settings with software other than the control panel of the machine,
NWADMIN, PCONSOLE, or NetSpot Device Installer, TCP/IP protocol must be
supported by your network environment.
4-2

NetWare Network Setup Procedures

NetWare Print Service Settings (See "NetWare Print Service Settings," on p. 4-3.)
Specify the NetWare print service settings. (You can only print or send a fax from a computer if the optional
equipment is installed. For the equipment needed, see "Optional Equipment and System Environment
Requirements," on p. 1-2.)
To specify the settings from the computer, use:
•
NWADMIN or PCONSOLE (Novell software provided with NetWare)
•
NetSpot Device Installer (Canon utility)
•
NetSpot Console (via a web browser) (Canon utility)
Protocol Settings (See "Protocol Settings," on p. 4-9.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Device Installer (Canon utility)
•
NetSpot Console (via a web browser) (Canon utility)
Computer Settings for Printing (See "Setting Up a Computer for Printing/Sending a Fax,"
on p. 4-17.)
Specify the settings of each computer you use for printing or sending a fax. (You can only print or send a fax
from a computer if the optional equipment is installed. For the equipment needed, see "Optional Equipment
and System Environment Requirements," on p. 1-2.)
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 4-18.)
Specify the settings of the computer receiving data sent from the machine. (You can only send data if the
optional equipment is installed. For the equipment needed, see "Optional Equipment and System
Environment Requirements," on p. 1-2.)