Netware Network Setup Procedures - Canon imageRUNNER C2550 Network Manual

NetWare Network Setup Procedures

To use a NetWare network, it is necessary to perform the following procedures.
1
4
2
3
4
IMPORTANT
•
If you are using the optional imagePASS, for steps 1 to 3, see the manual provided with
the optional imagePASS, not this guide.
•
It is recommended that steps 1, 2, and 4 above be performed by the network
administrator.
•
To configure settings with software other than the control panel of the machine,
NWADMIN, PCONSOLE, or NetSpot Device Installer, TCP/IPv4 protocol must be
supported by your network environment (IPv6 is not supported).
4-2

NetWare Network Setup Procedures

NetWare Print Service Settings (See "NetWare Print Service Settings," on p. 4-3.)
Specify the NetWare print service settings. (Optional equipment is required to print or send a fax from a
computer. For the equipment needed, see "Optional Equipment and System Requirements," on p. 1-2.)
To specify the settings from the computer, use:
•
NWADMIN or PCONSOLE (Novell software provided with NetWare)
•
Canon utilities (NetSpot Device Installer, etc.)
Protocol Settings (See "Protocol Settings," on p. 4-8.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
Canon utilities (NetSpot Device Installer, etc.)
Computer Settings for Printing/Sending a Fax (See "Setting Up a Computer for Printing/
Sending a Fax," on p. 4-12.)
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to
print or send a fax from a computer. For the equipment needed, see "Optional Equipment and System
Requirements," on p. 1-2.)
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 4-13.)
Specify the settings of the computer receiving data sent from the machine.